Maintenance cycle and troubleshooting of connecting rod lock
I. Introduction
Connecting rod lock is an important part of mechanical equipment and plays a key role in equipment operation. Reasonable use and maintenance can effectively prolong its service life and improve the overall efficiency of the equipment. This paper will discuss the matters needing attention in the practical application of connecting rod lock from two aspects: maintenance cycle and troubleshooting of common faults.
Second, the maintenance cycle
1. Daily inspection: Make a visual inspection every day before operation to see if there is any crack or damage; Also make sure that all bolts are tightened and there is no looseness.
2. Regular maintenance: thoroughly clean the connecting rod lock at least once a month and apply grease; Every six months, the internal parts should be disassembled and inspected for wear and tear, and the damaged parts should be replaced in time.
3. Annual maintenance: comprehensive inspection is required every year, including but not limited to hardness test, magnetic particle inspection and a series of professional means to evaluate whether the performance status meets the required standards.
Third, troubleshooting methods
1. The lock is not firm
If it is found that the target cannot be fixed normally due to insufficient locking force, it is first necessary to confirm whether the locking pin is completely inserted in place;
Secondly, it is necessary to check whether the spring force is strong enough to ensure sufficient pressure when closing;
Finally, it is necessary to adjust the gap size of each part to prevent the life from being affected by too small friction.
2. Difficult operation/serious sticking
This may be caused by long-term non-cleaning and maintenance, which causes dirt to accumulate between gaps and block the movement track.
At this time, the surface and internal impurities should be removed first and then oiled again;
In addition, we should also pay attention to regularly check whether there are obstacles in the gear transmission device or whether there are problems such as broken cogging;
When necessary, the load can be appropriately reduced to reduce the burden and relieve the symptoms.
Step 3 loosen and fall off
If you encounter this problem, you must first eliminate the influence of external factors such as vibration and shock.
Next, we will focus on the tightness of the screws at the joints, and take reinforcement measures (such as adding gaskets) or re-select products with appropriate sizes and specifications to replace the original models according to specific conditions.
IV. Conclusion
From the above analysis, it can be seen that it is very important to make a reasonable maintenance plan for connecting rod lock to ensure its normal operation. At the same time, we should also master some basic emergency handling skills to deal with unexpected situations. I hope this article can provide reference value for readers.
Rec. Prods.
标签：
本文地址：https://tepinji.com/Machi/588.html