Spherical lock is a common type of door lock, which is widely used in home and office because of its beautiful and practical characteristics. Correct installation and disassembly of the ball lock is very important to ensure its normal use. The installation and disassembly steps of the ball lock will be introduced in detail below.

I. Installation of Spherical Lock

Prepare tools and materials:

A set of spherical locks (including inner handle, outer handle, lock body, fixing screws, etc.)

Screwdriver

Drilling tools (such as electric drills and bits of corresponding size)

Installation steps:

1. Measurement and positioning: First, determine the position of the lock on the door, and mark the position to be punched with a pencil. Usually, the distance from the ground to the center of the lock cylinder is about 92 cm.

2. Drilling: Use a suitable drill bit to drill holes according to the marks made before. Ensure that the hole location is accurate and the depth is moderate. If you are not sure how to operate, please refer to the product manual or consult a professional.

3. Assemble the lock body: insert the lock body into the pre-opened hole, and put the matching fixing piece from the other side, and screw it down and fix it. Pay attention to check whether the locking tongue can expand and contract freely.

4. Install the inner and outer handles: firstly, pass the inner handle through the small hole in the middle of the lock body and fix it with screws; Then insert the outer handle and fix it. Make sure that the two handles are aligned and rotate smoothly.

5. Adjustment details: Finally, check whether all components are firm and reliable, and make appropriate adjustments to achieve the best condition. For example, the extension length of the lock tongue can be changed by adjusting the screw to make it closely fit with the door frame.

6. Test function: After completing the above steps, repeatedly try to open and close the door to confirm the normal operation of each function.

Second, the ball lock disassembly

Disassembly steps:

1. Prepare tools: Basic tools such as screwdrivers are also needed.

2. Remove the handle: use a screwdriver to gently unscrew the fixing screw at the bottom or side of the handle, and then remove the inner and outer handles.

3. Take out the lock body: loosen the fixing screw on the inside of the lock body and carefully pull out the whole lock body from the door.

4. Cleaning and maintenance: If it is only for cleaning and maintenance, the internal structure can be further disassembled and cleaned with a soft cloth.

5. Reinstallation: gradually restore all parts in the reverse order before, and ensure that each joint is stable enough.

The above is the introduction of the basic process of installing and disassembling the ball lock. In the whole process, we need to pay attention to safety issues to avoid accidental injuries or other losses caused by improper operation. In addition, when choosing a specific model, we should also consider factors such as cost performance in combination with actual needs, and purchase authentic goods with reliable quality. I hope this article can help you better understand and master relevant knowledge and skills!

标签：

本文地址：https://tepinji.com/Machi/3439.html